Shims Big Block

Thanks for visiting our site!
Shims Big Block
Checkout Ebay Auctions For The Cheapest Prices

Check out Amazon:

Account limit of 2000 requests per hour exceeded.

Featured Article :

If you're like me, I'm sure at some time you've tried to open your door or a window only to have it stick. The first time you just ignore the problem. Many times after a year or so, you find yourself telling your guests, "turn the knob the other way or it will stick". We all have a tendency to put things off as long as they still work somewhat. Windows and doors can stick for a number of reasons. Sometimes wood expands and contracts, parts may have been painted over two parts may be get fused together. Once you determine the cause, you can fix it yourself.

After a recent installation of a bay window, I found that the contractor had painted the windows closed. If paint is the culprit, you can scrape or cut it out with a putty knife or window zipper. Hold it flat against the sash, push it into the joint, and draw the zipper along the surface. If there is year's accumulation of paint, remove the excess paint with a paint scraper. Make sure you get all the parts that have excess paint, opening and closing the window throughout the process. You may have to remove the window to scrape paint off the sash. If this doesn't work, you may have to strip the paint down to the bare wood and repaint them. A commercial painter remover will do the job well. Make sure the paint is thoroughly dry before you reinstall the window or you'll have the same problem.

If the problem is too much friction, you can use candle wax or talcum powder to lubricate the channels of the sash. If weather-stripping is in the sash channels, flatten the weather strip with a hammer and block of wood.

If you can't seem to find what's causing the problem, you may have to just jar it loose a little with a rubber mallet or the palm of your hand. Gently tap the sides of the sash. You may want to install new friction channels. You'll need to remove the sashes, weights and pulleys before you begin. Push some fiberglass insulation in the openings of the weigh cavities, starting at the top and working down. Put in the ends of the top strip to make new friction channels. A sharp chisel and hammer works well for this. Replace the sashes in the window frame between the two new channels. You can then reinstall the interior stops the way you would if they were new. You may have to increase or decrease the tension on the window.

Doors usually stick for similar reasons except for the additional problems hinges may cause. Occasionally the door will rub against the jam, in which case, you need to shim the hinges out. If the rubbing is on a side where there are no hinges, you may need to readjust the door. Remove the door and use a plane to shave some of the door until it fits. Other simple problems such as loose screws or hinges can be easily fixed by tightening them.

Ray Walberg repeatedly makes articles on issues dealing with adding a bay window and curtains for bay windows. You can see his publications on bay window installation at http://www.replacement-windows-tips.com

Maintenance and Repairs Q&A

$1,800 to stratum my 1400 sq. ft. house.WTF ?
I have a 1400 sq. ft. home on pier & beam, adjectives it needs is some shimming to help close something like 4 or 5 doors, all of the blocking is pretty much in place, reasonably a few, I might add. It just really desires some tweaking in several places,...

$60 per foot for Rinnai vent pipe?
My plumber says the vent pipe for a Rinnai tankless water electric fire costs $60 per foot, plus the cost of the labor to install it. It's concentric vent pipe, with the exhaust gas in an inside pipe, and the intake nouns in the area between that inside pipe...

"ok how does one verbs black mold of attice boards underneath contemporary roof boards"?
i had a new roof put on 2 yrs ago = so we tore the celling down to put unusual dry wall= there was black mold on celling of trial baords put down when the roof was done =so befor putting new dry wall up how do you verbs the...

(16 amp?) electric cooker point - how much will this cost?
Our current cooker only uses a standard 13 amp plug socket (which is situated behind the cooker). We are thinking of getting a topical cooker and this will require hard wiring by a qualified electrician into a 16 amp cooker point. I hold two questions:- 1. Can the standard...

**ROAHCHES** please HELP??
I live in an apartment. We have abundant roaches & centipedes. My boyfriend bought the roach traps where it has food & the roach brings it to his little kith and kin & then they supposedly die. BUT i wanted to take the roach motel or the...

1.5 yr. ancient dryer is bang! Help!?
We do a lot of laundry here, and it still dries ok but the banging is making me crazy! Any notion what is causing that? Is it something I can fix or do I need to call upon a repair person? Don't recall if it's still beneath...

10 year antiquated owner fry pump?
compressor is locked up. two choices $1000. to replace compressor or $4600. to replace entire heat pump inside and out? what would be the best? are these quotes average?

10' X 30" pool- Is a vacuum required if it have a filter?
It is one of those inflatable pools that includes a filter with chlorine tablets. Despite my efforts of keeping it covered when not within use and stepping in a pan of marine to prevent debris from getting in, the wet is somewhat cloudy and mud is settled on the...

12 volt out door lighting I enjoy 4 walkway lights 7 watts respectively and a 150 watt hadco transformer.?
Im having bulbs burnout every few weeks? im using 12 guage wire.voltage at respectively fixture is 11.9 to 12.2 volts the lights are within 60ft from the trans former. voltage at the house fixture is 118 volts. why are the bulbs burning out.?

125 Amp Convertible Sub Panel?
yes what is the convertible mean. i want to put this in my garage. i hold a 200 amp box in my basement and 2 (double) 30 amp breakers running 12/3 which i believe is 220 and its running nearly 100 feet. can i put this 125 Amp...

1956 GE fridge wants freon?
I have a 1956 GE combonation fridge that I restored. I love it! But it is not keeping things very cold these ultimate few days. Does it need freon? I have be using it for about a year now near no problems. If it does need freon, how do...

1yr ripened Troy-Bilt 21" push mower...Honda engine...starts next dies after cranks...?
last night it worked properly while i mowed the front yard, but starting losing power (like if you got into some really giant grass and it was a little much for the mower). when i get to the back it just stopped. it would crank when i pulled the cord,...

2 opening mirror?
How do you identify a 2 way mirror from a one way mirror? gratefulness.

2006 Whirlpool estate electric dryer problem. Please oblige.?
I purchased a house with appliances included. The 2006 electric Whirlpool Estate Dryer looks brand new (very little lint even contained by the trap). First time running it blew my 220 line fuse (just thought it was an matured fuse). After replacing it dryer went a full cycle fine. The...

220 volt outlet ac plug is 3 foot too short?
Is it okay to use an extension cord? I only need a few foot. 220volt uses half the amps so wouldn't it be safer than the people using extension cords contained by a 110 outlet? Its's a 3 prong square outlet not the circle type. If...

220-volt outlet, incorrect voltage -- effect on dryer?
I've had one dryer basically burn out, and a second one runs but does not grill. (The first one was a more conventional one, while the second one is a very electronic Whirlpool Senseon.) A friend be here to try to diagnose the problem yesterday. He found nothing wrong...

23 spray head!?
23 spray heads? I was walking beside my friend when i saw someones underground sprinklers turn on and he had 23 sprinklers to 1 zone! how is this possible, it was purely a residential no pump and they didn't have that much pressure but they still worked to do the...

230 vs 115 V nouns conditioner?
Would it make any difference in my electricity bill to use a 12K btu's nouns conditioner if its a 230V or a 115V some people have told me that the 230 V will be cheaper but I'm not sure. thankfulness

230V 1 phase pool pump electric wiring?
My boss asked me to install a new pump into a pool and the person who took it out didn't splodge the wires. if there is one green and two black wires. do i just hook the two blacks to L1 and L2 on the motor and the ground...

3 course switch- 2 hots and 1 colourless?
When updating my wall switches, I didn't transfer the wires correctly. I have 2 red wires and a white line. While testing each flex seperatly, 1 red wire and 1 white wire made the device night light up and 1 red wire did not light. I'm assuming this medium it's...

3 phase converter cross-examine?
What is the cheapest/most efficient device to convert a delta phase (208) to a 120 volts?? We only hold 70 amps ,(#4) coming in through the 120v feeds, and yearning to increase the total amperage possibilities,and were wondering if we could transform or convert the 208v to 120v,...

3 seperate switches, socket recieves power but no lights?
I decided to update my switches, now none of the lights turn on from this specific box. 2 way-3 way- 2 route set up. With the switch on, the socket of the correct light will detect power using a voltmeter (120w). I have checked the electric wiring and reset the...

3 swimming pool question...?
Just wondering if it is safe to run my swimming pool pump when it is raining? Also, should it be covered when not in use to protect it from the elements? Lastly, I cleaned the filter for the first time today after have it installed Monday & it was all...

3 yr frail home. The interior pantry door swings unseal unless fully shut. Worked fine until just now. Suggestion?
Home is 3 yrs old. Door never had a problem. Now, it slowly swings open all the way by itself unless it one shuts it fully closed by the latch. Door is within a typically pre fab builder door jam inside our very nice kitchen near wood flooring. Has...

3.75 hsp push mower stopped running..?
I put a new spark plug in. My husband and I thought it might be river in gas so dumped out old gas and put unusual gas into mower starts but then stops running. My husbad even pushed it about 3 foot steps and it stopped running. What could...

3/4 ton A/C system how much freon does it rob to crowd the system?
Does the freon go on the cold side or normal heat pipe?

30 match next, propane torch still won't ignite?
What does it mean when you are trying to light a propane torch, in attendance is plenty of gas in it, it worked 15 minutes ago, but now you preserve lighting matches and holding it to the gas which is coming out but it doesn't ignite? I can't produce a...

30 Year old-fashioned Masonite Siding Problems?
Would 30 yr old masonite (fibre cement ) siding that has be wettened from watering plants from last owner be causing mildew smell within house? I have done everyi interior tear out including undlerlayment. no source of mildew but still stinky house. Does the dampen permeate thru that kind of...

42 inch big eyeshade get showery and shut sour?
it is pouring where i live and my roof leaked within my apartment and it was all down the vertebrae of my 42 inch akai big screen. It was on at the time. I didnt hear it pouring because i be listening to music but i turned around to look...

7 wires on a room hanger-on - what is respectively lead for?
Had a floor model room fan that had 3 speeds. It only just quit working. I took it apart & saw that under the touch control panel, there be a blown fuse on the board. I replaced it but still wouldn't work. My wife...

More Maintenance and Repairs questions please visit : HomeAVA.com More than 13,000 Home DIY Questions and Answers

About the Author

HomeAVA.com

1994 Dodge Viper RT/10 Meets 2009 Dodge Viper SRT10
The Viper may have changed through the years, but its proportions have stayed the same. | October 22, 2010 | Kurt Niebuhr for Edmunds For the time being, the Dodge Viper is a zombie, stuck between the living and the dead.

Thanks for visiting!